anaisa franco: November 2006

Wednesday, November 29, 2006

technical drawing- legs bones

Monday, November 13, 2006

drill the holes

drilling the holes.

painted the circuit board.
this is the circuit board to the leg's scars.
it will be 36 LEDS depending on leg's virtual trauma.

Thursday, November 09, 2006

designing legs

dream in the hospital

I needed to give something to the hospital..
something like an exam.
This thing should come out of my body.
It was difficult.
My father was with me..
We were in a hurry, going to travel, but i could not get this thing out of me.
Then I found a similar material on the ground.
The material was white.. similar to plastic or silicone..
It was round and next to it there was a white ball with a smooth surface..
I thought I would take them and give as if they came from me because mine should be very similar.
I was about to give them to the hospital when suddenly the real thing came out of my pants, my thing!
It was a bit different from the others.
Mine was light yellow, bigger, not round and it was wrinkled.
So I gave mine to them.
I went to travel with all my family.

Inside the hospital.. between the corridors..
In a door..
There was a biological leg being built in a strange lab..
I had some connection with that anyway..
I was trying to understand that leg.. it was mine..
I had to improve it but I was confused.
It must be done.

building small robots- session 2

robot legs technology

the robot legs will be programmed with Arduino board http://www.arduino.cc/

the motor used is GEARBOX AND MOTOR 148:1 - 4.5 TO 15V RC
http://www.rapidonline.com/netalogue/specs/37-1238e.pdf

I am using also a bridge to run the motor :: L6203 FULL BRIDGE DRIVER
http://www.datasheetcatalog.com/datasheets_pdf/L/6/2/0/L6203.shtml

the digital print boards to do the LED legs cicatrizes and the circuit board uses the software from Labcenter electronics :: ISIS professiona and PROTEUS 6 Professional. see the drawings of the circuits above.